Problem pairing MAX! Eco Switch using CUL

[alangward]

Recently the batteries gave up on my ECO switch.
I replaced them, but the light on the front stays on permanently and I cannot pair it.
It is transmitting OK as I can see its initial output in the log.

I originally installed it with a MAX! Cube, before I started using FHEM.
When I switched from the MAX Cube to a CUL I just re-assigned the same RF address to the CUL so all my devices continued to be paired - hence this Eco Switch continued to work.

Any ideas?,
Thanks

Alan

[RaspiLED]

Hi,
please give us the details in Code Tags.

Code Auswählen Erweitern

list <Device>
list <CUL>
Gruß Arnd


Signalduino (Nano, ESP, ...), CUL (Busware, Nano, Maple, ...), Homematic (HM-MOD-UART-RPI, ESP, Maple, ...), LaCrosseGateway (LGW, ESP, ...), 1-wire, ESPEasy, Bravia, Yamaha, ...

[alangward]

Hi
Thanks for your reply.
I've not been around - so only just seen it.

I have attached a short text file that contains the lists requested.

Thanks,
Alan

[RaspiLED]

Hi,
First of all not a attachment but please use the code tags like I did in my Post.

Secondly I asked for the list of the CUL!

What is that MAX_C is it a CUBE?
Why is the IODev in the Switch still CUBE?
What did you exactly change?
How dies the Eventmonitor look like when you try to pair?
What is in the log?

Warm regards,
Arnd


Signalduino (Nano, ESP, ...), CUL (Busware, Nano, Maple, ...), Homematic (HM-MOD-UART-RPI, ESP, Maple, ...), LaCrosseGateway (LGW, ESP, ...), 1-wire, ESPEasy, Bravia, Yamaha, ...