I'm trying the setup a couple of action intertek/eurodomest type 972080 "intertechno" self learning switches.
- I can read the remote commands with a-culfw (but the value varies, it's very unstable, possibly wrong)
- I can use the old intertechno V1 12-bit code learned into the switch with CUL (but I cannot figure out a code that is compatible with the original remote).
I cannot use the data from the remote read by a-culfw to learn the switch, so I can use the remote control and FHEM (CUL433).
I managed to figure out the raw data from the remote. I can use this data with the raw command "G" to learn and operate the switches:
Oviously, the first part should be more ore less the same; "0030a2143739100e" and the last 5 bytes are data. Question; how can I use this data to use it with FHEM?