Autor Thema: ENOCEAN PI 868  (Gelesen 1107 mal)

Offline littlelegs

  • Newbie
  • Beiträge: 1
ENOCEAN PI 868
« am: 13 Februar 2022, 23:39:41 »
Hi. I have connected the Enocean module to my raspberry pi and installed fhem which has been discovered.
I have a aico smoke detector which runs homelink and connects the smoke detectors via RF. is there any way I can use fhem with the Enocean transceiver to receive and relay any messages sent over RF? I would ideally like to forward the RF messages to home assistant to enable me to get notifications if the smoke detector is set off when I am away from home.

Many thanks.

Offline MadMax-FHEM

  • Hero Member
  • *****
  • Beiträge: 12412
  • NIVEAu ist keine Creme...
Antw:ENOCEAN PI 868
« Antwort #1 am: 14 Februar 2022, 00:03:31 »
There are more things than just frequency: protocol!

The frequency of the enocean module is 868MHz but it only can "talk" enocean "language"...

So receiving of any rf signal in 868MHz: yes
Understand: probably not
Forward: no

Regards, Joachim
« Letzte Änderung: 14 Februar 2022, 00:05:26 von MadMax-FHEM »
FHEM PI3B+ Bullseye: HM-CFG-USB, 40x HM, ZWave-USB, 13x ZWave, EnOcean-PI, 15x EnOcean, HUE/deCONZ, CO2, ESP-Multisensor, Shelly, alexa-fhem, ...
FHEM PI2 Buster: HM-CFG-USB, 25x HM, ZWave-USB, 4x ZWave, EnOcean-PI, 3x EnOcean, Shelly, ha-bridge, ...
FHEM PI3 Buster (Test)

Offline rudolfkoenig

  • Administrator
  • Hero Member
  • *****
  • Beiträge: 25614
Antw:ENOCEAN PI 868
« Antwort #2 am: 14 Februar 2022, 10:02:42 »
Zitat
There are more things than just frequency: protocol!
...and modulation and datarate and encoding and ... :)

 

decade-submarginal