As my EM1010PC tends to stuck and return exactly the same value for
hours, I'd like to be able to reset it automatically. The reset until
now was not of much use: you had to confirm the time/date manually on
the EM1010PC directly after the reset command was sent by fhem (or by
the Windows software).
After sending each possible one-byte command to the EM1010PC I found
one command which will skip the manual interaction, going to the sync
mode after reset, I added this command to the reset sequence, and
made the change available in CVS.
My EM1010PC has firmware version 1.5 (upgraded from 1.2), I would be
grateful if some of you would confirm that it is working.
Greetings,
Rudi
--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups "FHZ1000 users on Linux" group.
To post to this group, send email to FHZ1000-users-on-unix@googlegroups.com
To unsubscribe from this group, send email to FHZ1000-users-on-unix-unsubscribe@googlegroups.com
For more options, visit this group at http://groups.google.com/group/FHZ1000-users-on-unix?hl=en
-~----------~----~----~----~------~----~------~--~-