Raspberrymatic (CCU3) anlernen von HM-SEC-WDS-2 und fhem schlägt fehl

[LT@Home]

createDev liefert:

Code Auswählen Erweitern

Results of create command:
Not detected CCU devices:
  KG.AT.Sensor.Wasser = OEQ0129610 [KG.AT.Sensor.Wasser]

get deviceInfo liefert:

Code Auswählen Erweitern

Device channels and datapoints

DEV KG.AT.Sensor.Wasser OEQ0129610 interface=BidCos-RF type=HM-Sec-WDS-2
CHN OEQ0129610:0 KG.AT.Sensor.Wasser:0
   0.UNREACH = false {b} [RE]
   0.STICKY_UNREACH = false {b} [RWE]
   0.CONFIG_PENDING = false {b} [RE]
   0.LOWBAT = false {b} [RE]
   0.RSSI_DEVICE = -65535 {i} [RE]
   0.RSSI_PEER = -66 {i} [RE]
   0.AES_KEY = 0 {i} [R]
CHN OEQ0129610:1 KG.AT.Sensor.Wasser:1
   1.STATE = 0 {i} [RE]
   1.LOWBAT = false {b} [RE]
   1.INSTALL_TEST =  {b} [E]

Device detection:
No state datapoint detected
No control datapoint detected

Failed to detect device settings. Device must be configured manually.

Device description

Device OEQ0129610 KG.AT.Sensor.Wasser [HM-Sec-WDS-2]
  CHILDREN: OEQ0129610:0,OEQ0129610:1
  FIRMWARE: 1.4
  FLAGS: Visible
  INTERFACE: PEQ1944819
  PARAMSETS: MASTER
  RF_ADDRESS: 5615712
  ROAMING: 0
  RX_MODE: ALWAYS,LAZY_CONFIG
  UPDATABLE: 0
Channel OEQ0129610:0 KG.AT.Sensor.Wasser:0 [MAINTENANCE]
  AES_ACTIVE: 0
  DIRECTION: NONE
  FLAGS: Visible,Internal
  PARAMSETS: MASTER,VALUES
  PARENT: OEQ0129610
  PARENT_TYPE: HM-Sec-WDS-2
Channel OEQ0129610:1 KG.AT.Sensor.Wasser:1 [WATERDETECTIONSENSOR]
  AES_ACTIVE: 0
  DIRECTION: SENDER
  FLAGS: Visible
  LINK_SOURCE_ROLES: KEYMATIC,SWITCH,WINMATIC
  PARAMSETS: LINK,MASTER,VALUES
  PARENT: OEQ0129610
  PARENT_TYPE: HM-Sec-WDS-2


was muss/kann ich tun?