FHEM Forum

I think one can be removed, since it's not valid anymore (attr manufID missing?)
Keep the one that starts at L#22303.

@ -19219,37 +19219,6 @@
      </li>
      <br><br>

-     <li>Gateway (EEP A5-38-08)<br>
-         Dimming<br>
-         [Eltako FUD12, FUD14, FUD61, FUD70, FSG14, ...]<br>
-     <ul>
-      <code>set &lt;name&gt; &lt;value&gt;</code>
-      <br><br>
-      where <code>value</code> is
-        <li>dim/% [rampTime/s [lock|unlock]]<br>
-          issue dim command</li>
-        <li>teach<br>
-          initiate teach-in mode</li>
-        <li>on [lock|unlock]<br>
-          issue switch on command</li>
-        <li>off [lock|unlock]<br>
-          issue switch off command</li>
-        <li>dim dim/% [rampTime/s [lock|unlock]]<br>
-          issue dim command</li>
-        <li>dimup dim/% [rampTime/s [lock|unlock]]<br>
-          issue dim command</li>
-        <li>dimdown dim/% [rampTime/s [lock|unlock]]<br>
-          issue dim command</li>
-        <li><a href="#setExtensions">set extensions</a> are supported.</li>
-     </ul><br>
-        rampTime Range: t = 1 s ... 255 s or 0 if no time specified,
-        for Eltako: t = 1 = fast dimming ... 255 = slow dimming or 0 = dimming speed on the dimmer used<br>
-        The attr subType must be gateway and gwCmd must be dimming. This is done if the device was
-        created by autocreate.<br>
-        For Eltako devices attributes must be set manually. Use the sensor type "PC/FVS" for Eltako devices.
-     </li>
-     <br><br>
-
     <li>Gateway (EEP A5-38-08)<br>
         Dimming of fluorescent lamps<br>
         [Eltako FSG70, tested with Eltako FSG70 only]<br>


The texts are different. First, the set commands are listed, then the resulting events.

I see but is this snippet still valid?
Use the sensor type "PC/FVS" for Eltako devices.

Why not? Unfortunately, Eltako changes the names in the instructions from time to time. In addition, the names in the English and German manuals are often different.