Hi
My configuration is raspberry with USB300 EnOcean Controler
I bought a smart plug NOD_ASP-2-1-00 Nodon
It has been discover by FHEM
if i press the button on the plug it self i can see events like
fhem> 2017-01-02 14:14:34 EnOcean EnO_VLD_0185B076 0460E4
fhem> 2017-01-02 14:14:35 EnOcean EnO_VLD_0185B076 046080
Now how to active my plug from FHEM ? set command ?
fhem> list EnO_VLD_0185B076
Internals:
DEF 0185B076
IODev TCM310
LASTInputDev TCM310
MSGCNT 6
NAME EnO_VLD_0185B076
NR 22
STATE 046080
TCM310_DestinationID FFFFFFFF
TCM310_MSGCNT 6
TCM310_PacketType 1
TCM310_RSSI -91
TCM310_SecurityLevel 0
TCM310_SubTelNum 1
TCM310_TIME 2017-01-02 14:14:35
TYPE EnOcean
Readings:
2017-01-02 14:14:35 state 046080
Attributes:
room EnOcean
subDef FF000000
subType VLD
webCmd on:off:dim
please help
thanks
Hello,
I checked the Website http://nodon.fr/en/enocean/enocean-smart-plug_3-1 and found the information that your Device should supports EEP – D2-01-0A (if you have the plug without metering function).
Looking at your config I miss the attribute for teach-in as well as the EEP attribute.
I am not sure if you have made the initial teach in for the smart plug to your TCM controller. If you haven't done so, please read the manual of your plug-in a figure out how to start the teach-in procedure. Once you have started the procedure, set your TCM in teach mode ( SET [TCMdevicename] TEACH 30 ) and then your FHEM should detect the device properly and also set the attribute for teach-in and EEP properly.
About your question "who to activate your plug from FHEM:
Looking at the webcmd, you see already that FHEM suggest the commands ON, OFF and DIM.
So I assume that if you enter the command
SET EnO_VLD_0185B076 ON
will switch the plug on. But prerequisite for this is that the teach-in has took place properly and that the teach-telegram from the plug to the TCM controller transferred the proper EEP informations.
bye
Hi
Thanks for your help very usefull
Now all is working.
Two things to consider :
1/ I missed that my FHEM was not uptodate (i used this command to do so : update)
2/ I wasn't aware that i has to do a : set TCM310 teach 30 in order to add devices
Now your are right i have eep parameter in the definition (see below)
fhem> list EnO_0185B076
Internals:
CFGFN
DEF 0185B076
IODev TCM310
NAME EnO_0185B076
NR 28
NTFY_ORDER 50-EnO_0185B076
STATE ???
TYPE EnOcean
Readings:
2017-01-03 20:18:59 teach UTE teach-in accepted EEP D2-01-0B Manufacturer: ID-RF
Helper:
Attributes:
IODev TCM310
comMode biDir
defaultChannel 0
devChannel 1
eep D2-01-0B
manufID 046
room EnOcean
subDef FF9B2201
subType actuator.01
teachMethod UTE
Thanks a lots