Originally posted by: <email address deleted>
Hi,
I'm using an oregon device to measure the temperature and when collect
the data, a PID controller changes the actuator (fht8v).
Now every 40 seconds a temperature is collected and each time the
fht8v gets another value , and the fht8v changes that is very often
and not very good for batteries, and for the fht8v.
It should be nice that you can set an interval at the PID that it
looks once in 5 minute to the device and than changes the fht8v.
Is this possible that somebody can do this, or is there another
solution?
regards Richard
--
To unsubscribe from this group, send email to
fhem-users+unsubscribe@googlegroups.com