Originally posted by: <email address deleted>
Hi all (Willi),
I found the following (minor) issue with TRX_LIGHT:
A KAKU (AC) Chime / Doorbell is shown as TRX_ARC_A8. As soon as the
chime was activated is says "Chime" at the position where normally the
light-bulb is shown. After clicking the "Chime" URL, the URL is
replaced by the light-bulb again.
It would be nice to treat the Chime as new type of TRX_LIGHT device,
with just a Chime / Activate button (just as the button at the
door ;-)
Regards,
Eeg.
--
To unsubscribe from this group, send email to
fhem-users+unsubscribe@googlegroups.com
Originally posted by: <email address deleted>
Hello Eeeg,
I assume you use pgm2 as the user interface?
To be honest I do not know the algorithm how pgm2 displays icons.
I would suggest that you post additional information like "list TRX_ARC_A8"
and/or screenshots of the status and icons. Maybe one of the pgm2
specialists have an solution.
I have to admit that my FHEM installation is very basic. I spent too much
time writing modules......
I assume that pgm2 displays the bulb, because the status is "off" and
displays no icon when the status is "chime".
Best Regards Willi
--
To unsubscribe from this group, send email to
fhem-users+unsubscribe@googlegroups.com