Originally posted by: <email address deleted>
Hi
I can confirm that you shouldn't use AMST606 door/window sensors with the
Rfxtrx module. I thougt it was a different story as the pir sensors. :-(
I wonder if there is a way to find out if the rfxtrx module has rejected
fhem commands because it detected the swarm of signals from the AMST606
sensor. I can imagine that the rfxtrx modules sends some kind of nack back.
{HT}
--
To unsubscribe from this group, send email to
fhem-users+unsubscribe@googlegroups.com
Originally posted by: <email address deleted>
I have both sensors in use....without issues!
A KAKU PIR and a door sensor. Both are working fine, auto detected by means of FHEM icw RFXTRX
R.
Eeg.
--
To unsubscribe from this group, send email to
fhem-users+unsubscribe@googlegroups.com
Originally posted by: <email address deleted>
Sure, but the problem is that they generate so much traffic that the rfx
module stops sending messages for a few seconds. So when reacting with a
kaku command on a message of a kaku sensor it might be that this is never
sended.
Just open and close the door a few times after each other and let fhem
switch the light on when the door is opened. You will se the result.
{HT}
Op vrijdag 14 december 2012 17:07:48 UTC+1 schreef Superbert het volgende:
>
> I have both sensors in use....without issues!
>
> A KAKU PIR and a door sensor. Both are working fine, auto detected by
> means of FHEM icw RFXTRX
>
> R.
>
> Eeg.
>
>
--
To unsubscribe from this group, send email to
fhem-users+unsubscribe@googlegroups.com
Originally posted by: <email address deleted>
Yes, that's an issue I have seen.
I added a "sleep 4" before sending a command after receiving from some KAKU
actors.
I use the PIR and doorsensor just for detecting "at home", so for those
sensors I don't have much issues.
But I have to admit that there can be quite some traffic going on due these
sensors sending all the time....so this will for sure lead to interrupted
transmissions and missing receptions :-(
I guess that's the price for going "cheap".
Cheers,
Eeg.
Op zaterdag 15 december 2012 22:02:33 UTC+1 schreef dudler het volgende:
>
> Sure, but the problem is that they generate so much traffic that the rfx
> module stops sending messages for a few seconds. So when reacting with a
> kaku command on a message of a kaku sensor it might be that this is never
> sended.
>
> Just open and close the door a few times after each other and let fhem
> switch the light on when the door is opened. You will se the result.
>
> {HT}
>
> Op vrijdag 14 december 2012 17:07:48 UTC+1 schreef Superbert het volgende:
>>
>> I have both sensors in use....without issues!
>>
>> A KAKU PIR and a door sensor. Both are working fine, auto detected by
>> means of FHEM icw RFXTRX
>>
>> R.
>>
>> Eeg.
>>
>>
--
To unsubscribe from this group, send email to
fhem-users+unsubscribe@googlegroups.com