Neues Modul: Signalbot (Integration für den Signal Messenger) via signal-cli

Begonnen von Adimarantis, 31 Januar 2021, 19:16:19

Vorheriges Thema - Nächstes Thema

HarryT

Zitat von: Adimarantis am 29 Juni 2025, 14:05:15Maybe you should consider learning how to use git/github  :)

Point taken. I fiddle around a bit, at least I tried to add a comment for a type in your patch.
ZitatFor now I applied your patch there, but had to do some additional fixes, as you did not consider the case when no option and just "-y" is given. Please check

The code looks nice/clean and the addition is usefull but doesn´t work. I think there is a typo in it and I tried to enter a comment in the code. Hope you can see my comment.


I can´t see my own comment so I guess I failed. On line 32 it should be UNATTENDED I guess. (Missing D ) The same type is in 2 other places.
 
FHEM 6.4 auf Raspberry Pi3  (1,2 Ghz)
RFXTRX433XL, ZWave, KFL200 and ConBeeIII
Raspberry Pi1 (0,7 Ghz) and Raspberry Pi4 for testing
German reading skills are good.

Adimarantis

You're right, I had a couple of wrong spellings in the variable which magically where consistently correct for my test case.
Please check again now.

Jörg
Raspberry 4 + HM-MOD-RPI-PCB (pivCCU)/RfxTrx433XL/Zigbee
Module: 50_Signalbot, 48_HomeConnect, 52_I2C_ADS1x1x , 58_RPI_1Wire, (50_SPI_MAX31865)

HarryT

Jo Jörg

signal_install.sh works now correct for me.

>  which magically where consistently correct

And Murphy's Law is still valid :-)

Thanks for your work.

Harry
FHEM 6.4 auf Raspberry Pi3  (1,2 Ghz)
RFXTRX433XL, ZWave, KFL200 and ConBeeIII
Raspberry Pi1 (0,7 Ghz) and Raspberry Pi4 for testing
German reading skills are good.

kabanett

Hallo zusammen,
ich muss jetzt auch mal etwas erfragen.
Ich habe die Installation vor ein oder zwei Monaten durchgeführt und wollte mein Telegramm damit ersetzen.
Leider hat die Registrierung nicht funktioniert. Die letzte Fehlernummer ergab dem suchen nach, einen zu häufigen Versuch.
Ich habe die Nummer gelöscht und bis jetzt abgewartet.

Heute habe ich es erneut versucht. Methode ist auf Voice gestellt und Powershell ist auch aktiviert.
Nach lösen des Captcha öffnet sich kurz Powershell und danach die WebGUI von fhem mit folgenden Eintrag:

Error with captcha:Error in registerWithCaptcha:InvalidTransportModeException StatusCode: 400

Hatte ich damals auch schon... Wie verfahre ich denn jetzt am besten weiter?

Gruß

Hardware: Fhem auf Raspi3 / selbtsbau CUL 433 und 868 MHz / MAX Thermostate / IT-Dosen nur noch Weihnachten / diverse ESP Aktoren/Sensoren / X10 Fernbedienung / Shelly 1, 1L, 2, 2.5, Dimmer, RGB2 / LaCrosseGateway / Zigbee2531 / diverse Zigbee Aktoren/Sensoren